GRAPHTEC CE7000 Series - Setting the Speed

2-48
Setting the speed
Set the speed of the tool that is used in each of the condition numbers.
Setting range : CE7000-40 1 to10 (in 1 cm/s increment), 10 to 60 (in 5 cm/s increment)
: CE7000-60 1 to10 (in 1 cm/s increment), 10 to 60 (in 5 cm/s increment), 64
: CE7000-130 1 to10 (in 1 cm/s increment), 10 to 70 (in 5 cm/s increment), 71
: CE7000-160 1 to10 (in 1 cm/s increment), 10 to 70 (in 5 cm/s increment), 71
Supplement
•
In the CE7000-60, if speed is set to 64 and acceleration to 3 at the same time, the "*" will be displayed in the acceleration. In this
case, both values will be automatically calculated and the cutting plotter works with the values.
•
In the CE7000-130/160, if acceleration is se to 2, the speed cannot be set to 65 or more (65, 70, or 71). In this case, the "
*
" will be
displayed in the acceleration and both values of the speed and acceleration will be automatically calculated and the cutting plotter
works with the values.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION setting screen (1/3)
without changing the settings when you press
the [ESC] key (CANCEL).
2
Press the [3] key (SPEED).
SPEED setting screen is displayed.
* Display may vary depending on the selected tool condition number.
3
Press the POSITION ( ) keys and select the tool condition
number (CONDITION No.).
4
Press the POSITION ( ) keys and increase or decrease the
setting value.