2-30
2.6
Connecting to the Power
Turning on the power of the plotter.
Operation
1
Check that the power switch is turned off. (the " " side is
pressed down)
CE7000-130/160CE7000-40/60
2
Connect one end of the provided power cord to the CE7000
AC line inlet and the other end to an electrical socket of the
rated supply voltage.
* The gure below is CE7000-130.
Supplement
When turning the power off, wait over 20
seconds before turning it on again, otherwise
problems may occur with the display.
3
Turn on the CE7000 by pressing the "|" side of the switch.
LCD on the control panel is lit.
CE7000-130/160CE7000-40/60
Supplement
•
The Default Screen will appear after
purchasing the machine. See "About the
Default Screen" for more information.
•
This screen is described as "default screen"
in this document.
•
Settings such as initial media feed speed and
communication conditions can be performed.
4
If media has not been loaded, the rmware version number is
displayed, followed by a prompt to load media.
Media set lever raised
(The push roller is up)
Media set lever lowered
(The push roller is down)
To Next Page
Loading...
