GRAPHTEC CE7000 Series - Adjust the Blade Length (Automatic Height Adjust)

2-60
Adjust the blade length (Automatic Height Adjust)
Test cutting must be performed several times in order to conrm the optimal blade length setting. However, if the
blade length adjustment function is used, the optimal length can be easily set.
Supplement
•
In the case of the less than 1 mm adjustment , please use the supplied magnier.
•
The measured height is a guideline only. After attempting to cut the actual media, please adjust blade length accurately.
Operation
Supplement
Perform the settings in Normal mode.
1
Load the media for test cutting in the plotter.
2
Press the POSITION ( ) keys to move the tool
carriage to the location you wish to perform the blade length
adjustment.
3
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
4
Press the POSITION ( ) key.
CONDITION setting screen (3/3) is displayed.
5
Press the [4] key (BLADE ADJUST).
Message prompting to turn the blade-length adjustment knob is
displayed.