GRAPHTEC LABELROBO LCX603 - Page 100

4-2
Chapter 4 Menu Operation
4.1 Display When the Power is Turned On
Turn on the power to the unit.
When the media has been set, the following is displayed.
'
'
'
'
I N I T I A L I Z E
P L E A S E W A I T !
↓
'
'
'
'
I N I T I A L I Z E
P R I N T E R - V E R :
C U T T E R - V E R :
P L E A S E W A I T !
(The unit's PRINTER version number and CUTTER version number are displayed.)
↓
'
'
'
'
C o n f i r m C o m b i n a t i o n !
H 3 = S e m i - R H 2 = S e m i - R
H 1 = S e m i - R F N S m a t N 5 0
Y E S : E N T E R N O : E S C
(“ConrmCombination”isdisplayed.):“ConrmCombination!”Screen
'
'
'
'
C o n f i r m C o m b i n a t i o n !
H 3 = S e m i - R H 2 = S e m i - R
H 1 = S e m i - R F N S m a t N 5 0
Y E S : E N T E R N O : E S C
*OLSJCCPOTBOENFEJBUZQF
DVSSFOUMZVTFEBSFEJTQMBZFE
*OLSJCCPO
.FEJBUZQF
*OLSJCCPO
*OLSJCCPO
Select “YES” (ENTER) or “NO” (ESC).
When selecting “YES”, “READY” is displayed.
When selecting “NO”, “CONDITION LOAD/PRINTING DENSITY” is displayed.
'
'
'
'
C O N D I T I O N L O A D >
P R I N T I N G D E N S I T Y >
Return to Ready status by loading the saved “CONDITION” settings
Or return to Ready status by setting the media materials and ink ribbon set in “PRINTING DENSITY”.
For information on “CONDITION” and PRINTING DENSITY, please refer to “4.8 CONDITIONS” and “4.9 PRINTING
DENSITY” respectively.
• When the ENTER key or ESC key is pressed while all of the ribbon levers keep in the open position,
the following is display for about 3 seconds, and then returns to “ Confirm Combination!” Screen.
'
'
'
'
C o n f i r m c o m b i n a t i o n
o f r i b b o n a n d m e d i a !
T h e n s e t t h e r i b b o n
l e v e r .
• When all of the ribbon levers are opened while they are cloed, “ Confirm Combination!” Screen. Is
displayed. Close the ribbon levers that are to be used for print.
↓
'
'
'
'
R E A D Y
C O N D I T I O N - 0 1
READY Screen
'
'
'
'
R E A D Y
C O N D I T I O N - 0 1
%JTQMBZTUIFTFUDPOEJUJPOOVNCFS
• This screen is referred to as "Basic Screen: READY" in the manual.
• In this situation, the settings for print conditions, cut conditions, and communication conditions
are carried out from the LOCAL key or TOOL COND. key.