GRAPHTEC LABELROBO LCX603 - When the Nk RBbon or Label MaterAl S Wrapped up N the RBbon Roller

7-16
Chapter 7 Troubleshooting
When the Ink Ribbon or Label Material is Wrapped up in the Ribbon Roller
3JCCPOSPMMFS
Symptom/Cause
• When setting the ink ribbon, it can get wrapped up when the ink ribbon is slack.
Solution
• Wile slowly pulling the ribbon stocker, pull out the wrapped up portion.
• When setting the ink ribbon, make sure there is no slack. (Refer to "2.8 Setting the Ink Ribbon".)
(1) Open the main unit front cover, then remove the ribbon lever.
4UFQ
4UFQ
3FNPWF
UIFSJCCPOMFWFSTFU