4-10
Chapter 4 Menu Operation
4.8 CONDITIONS
You can record several setting conditions of all types, recall the setting conditions according to your objective, and
switch between them.
It is convenient when you record settings for each combination of media (materials) such as labels, ink ribbon, and laminate.
Ten CONDITIONS can be recorded.
The setting conditions SAVE MENU is as follows.
MEDIA TYPE
RIBBON TYPE
PRINTING DENSITY
ANTI-WRINKLE LINES
HEAD ADJUSTMENT
REGISTRATION MARK
UNIT LENGTH
FUNCTION SETTING
LAN SETTING
TOOL condition number (1 through 8) set with the TOOL COND. key.
Save the setting condition over the existing CONDITION 1 through 10.
Matching the media (material), set the recorded CONDITION number 1 through 10 and execute printing.
Refer to the respective items for each menu setting method.
'
'
'
'
R E A D Y
C O N D I T I O N - 0 1
%JTQMBZTUIFTFUDPOEJUJPOOVNCFS
CONDITION LOAD
This section will explain the CONDITION LOAD operation when the ESC key is pressed during displaying Confirm
Combination upon replacing the ink ribbon or media materials.
(1) Press the ESC key when “Confirm Combination” is displayed and the following is displayed.
'
'
'
'
C O N D I T I O N L O A D >
P R I N T I N G D E N S I T Y >
(2) Press the F1 key (CONDITION LOAD) and the following is displayed.
'
'
'
'
L O A D N O .
< 0 1 >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(3) Change the number (1 to 10) with the POSITION keys (
▲▼
), and set the CONDITION number that is to be called up.
Execute the CONDITION LOAD with the ENTER key to return to READY status.
Press the ESC key to return to the CONDITION (LOAD/SAVE) screen.
How to register CONDITION
Set the conditions that perform the CONDITION record.
(1) Press the LOCAL key from the READY status and the following is displayed.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
To Next Page
Loading...