4-42
Chapter 4 Menu Operation
Connecting with a Network (LAN) Cable
When connecting with a network (LAN), program the following items:
If the network settings are changed, it will be necessary to turn off the power once, wait at least 10
seconds, and then turn it back on. After turning the power back on again, the settings will become active.
• DHCP settings
• IP address input
• Subnet mask input
• Gateway input
• MAC address display
DHCP Settings
DHCP settings vary according to the network device configuration or your environment. Refer to your device's manual,
or contact your network administrator for details.
DHCP is turned off in the default settings.
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the below screen will display.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the below screen appears.
'
'
'
'
L A N S E T T I N G >
M A C A D D R E S S >
4 / 4
(4) Press the F1 key (LAN SETTING) and the below message will display.
'
'
'
'
D H C P >
I P A D D R E S S >
S U B N E T M A S K >
G A T E W A Y >
(5) Press the F1 key (DHCP) and the below message will display.
'
'
'
'
D H C P S E T T I N G
< O F F >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(6) Change to "ON" (use DHCP) or "OFF" (do not use DHCP) with the POSITION keys (
▲▼
) and program DHCP.
(Resetting will take time when DHCP is programmed on.)
Press ENTER to confirm and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.
The below screen will appear when turning the setting from "ON" to "OFF" or from "OFF" to "ON".
'
'
'
'
P R I N T E R I S R E S E T
Y E S : E N T E R N O : E S C
Press the ENTER key to reset. (Resetting will take time when DHCP is programmed on.)
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.
To Next Page
Loading...