GRAPHTEC LABELROBO LCX603 - 4.21 Cross Cut

4-38
Chapter 4 Menu Operation
4.21 CROSS CUT
Program to use or not use crosscut (horizontal cutting).
When programming to use crosscut, run horizontal cutting in the drawing rear after printing/cutting.
• The cross cutting operation occurs close to the outlet. Take full care not to injure your fingers from the
blade.
• Cross cut is for cutting the backing sheet of label materials following the separator. There may be uncut
materials if you try to cut label materials by backing sheet or with attached laminate materials. Also, the
crosscut section might be damaged if the label material glue attaches to the blade. Do not cut anything
other than the backing sheet.
• The lifespan of a crosscut cutter blade is approximately 10,000 times.
• When cross cut is conducted after the device been left unattended for a long time with label
materials set in place, the cross cut function of the printer may be impaired. Be sure to remove
label materials if the device is going to be left unattended for a long time.
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the below screen will display.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the below screen appears.
'
'
'
'
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
(4) Press the F3 key (FUNCTION SETTING) and the below message will display.
'
'
'
'
L A M I N A T E >
S E P A R A T O R >
C R O S S C U T >
F R A M E C U T >
(5) Press the F3 key (CROSS CUT) and the below message will display.
'
'
'
'
C R O S S C U T S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(6) Change to "ON" (use crosscut) or "OFF" (do not use crosscut) with the POSITION (
▲▼
) keys and program
crosscut.
Press ENTER to confirm and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.