4-49
Chapter 4 Menu Operation
4.26 OFFSET FORCE
Run offset force to confirm the direction of the blade tip during initial operations, and program the cutting force of the
blade tip default control.
In addition, program default value "4" and cutting pressure will increase to a large value.
In order to correctly position the blade tip in the cutting direction, run the cutting operation for a short while before
engaging in a full cutting operation. A high cutting force is unneeded at this time, and so a cutting force lower than
usual is programmed as the offset force.
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F2 key (CUTTER MENU) and the below screen will display.
'
'
'
'
B L A D E C O N S U M P T I O N >
T O O L U P / D O W N >
O F F S E T F O R C E >
(3) Press the F3 key (OFFSET FORCE) and the below message will display.
'
'
'
'
O F F S E T F O R C E
< 0 4 >
I N P U T : ↑ ↓
Y E S : E N T E R N O : E S C
Change the numerical value (1 to 31) with the POSITION keys (
▲▼
) and program the offset force.
Press ENTER to confirm the gateway and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.
To Next Page
Loading...