GRAPHTEC LABELROBO LCX603 - 4.20 Separator

4-37
Chapter 4 Menu Operation
4.20 SEPARATOR
Program to use or not use the separator.
When programming to use the separator, roll up the unnecessary media parts after printing/cutting.
• When this menu setting and the set-up condition of this main unit are not in agreement, an error
will occur and it will not be possible to print.
• When programming to not use the separator, always remove the separator from the stocker. If they
are left set, an error will occur and it will not be possible to print.
• When programming to not use the separator, always set the separator. If they are not set, an error
will occur and it will not be possible to print.
• Refer to "2.10 Using the Separator" regarding setting the separator.
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the below screen will display.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the below screen appears.
'
'
'
'
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
(4) Press the F3 key (FUNCTION SETTING) and the below message will display.
'
'
'
'
L A M I N A T E >
S E P A R A T O R >
C R O S S C U T >
F R A M E C U T >
(5) Press the F2 key (SEPARATOR) and the below message will display.
'
'
'
'
S E P A R A T O R S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(6) Change to "ON" (use separator) or "OFF" (do not use separator) with the POSITION (
▲▼
) keys and program the
separator.
Press ENTER to confirm and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.