4-19
Chapter 4 Menu Operation
4.13 PRINT AND CUT POSITION ADJUSTMENT
When there is a shift in the cut position and the cutter section registration mark reading sensor, it is possible to
compensate by entering a correction value.
In printing with Head 3 (ribbon 3), the registration mark reading sensor and the tool holder position are adjusted.
First print the adjustment pattern, then cut with the cutter attached in the tool holder as the registration mark standard.
When handling the cutter blades, take full care not to cut your hands.
• Set the cutter pen in the tool holder.
• Always set a black ribbon for Head 3 (ribbon 3).
• Refer to "2.14 Adjusting the Blade Length" with regards to blade length adjustment methods.
Print and Cut Adjustment Pattern Instructions
'FFEEJSFDUJPO
1SJOUFEDSPTT3JCCPO 3FHJTUSBUJPONBSLT4UBSUNBSL
QBHFTQBHF
1SJOUFEDSPTT
The registration mark is printed as 3 points.
Print and Cut Adjustment Pattern
(1) Press the LOCAL key from the READY status and the following is displayed.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the following is displayed.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the following is displayed.
'
'
'
'
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
(4) Press the F2 key (PRINT TEST PATTERN) and the following is displayed.
'
'
'
'
P R I N T T E S T P A T T E R N >
A D J U S T P & C P O S I T I O N >
(5) Press the F2 key (ADJUST P&C POSITION) and the following is displayed.
'
'
'
'
P R I N T A D J U S T M E N T
P A T T E R N ?
Y E S : E N T E R N O : E S C
To Next Page
Loading...