GRAPHTEC LABELROBO LCX603 - Page 118

4-20
Chapter 4 Menu Operation
(6) Press the ENTER key, and 5 pages of crosses (+) for the adjustment reading are printed.
'FFEJOHEJSFDUJPO
1SJOUFEDSPTT3JCCPO 3FHJTUSBUJPONBSLT4UBSUNBSL
QBHFTQBHF
(7) Read the "Start Mark" and "Registration Mark", then cut the adjustment cross (+) on the first age with the cutter pen
set in the tool carriage.
'FFEEJSFDUJPO
1SJOUFEDSPTT
QBHFTQBHF
(8) After the cut, the following is displayed.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
(9) Based on the crosses (+) for the correction reading that was read, measure how far you must slide the correction
crosses (+) cut for comparison so that they overlap (cut the center of the printed crosses (+)), and record the value.
'FFEEJSFDUJPO
QBHF
9BNPVOUPGWBSJBODF
:BNPVOUPGWBSJBODF
:
9
$PSSFDUJPOJOQVU9
$PSSFDUJPOJOQVU:
$VUDSPTT
1SJOUFEDSPTT
For example in the above illustration, direction x and direction y are both misaligned in direction plus (+). As such,
it is necessary to correct to direction minus (–).
Each correction value will become a negative value.