GRAPHTEC LABELROBO LCX603 - Page 119

4-21
Chapter 4 Menu Operation
(10) Press the F2 key (X-POSITION ADJ) and enter the correction value for direction x.
'
'
'
'
X - P O S I T I O N A D J U S T
< 0 . 0 > m m
A D J U S T : ↑ ↓
Y E S : E N T E R N O : E S C
Change the numerical value (-1.5 to +1.5) with the POSITION keys (
▲▼
) and program the correction value .
Press ENTER to confirm and return to the previous screen.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
(11) Press the F3 key (Y-POSITION ADJ) and enter the correction value for direction y.
'
'
'
'
Y - P O S I T I O N A D J U S T
< 0 . 0 > m m
A D J U S T : ↑ ↓
Y E S : E N T E R N O : E S C
Change the numerical value with the POSITION keys (
▲▼
) and program the correction value.
Press ENTER to confirm and return to the previous screen.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
Verify Results After Correction -1
(1) Enter the correction values for both the X direction and the Y direction, and confirm the results.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
(2) On the above display, press the F4 key (CUT CONFIRMATION), and the following is displayed.
'
'
'
'
C O N F I R M A D J U S T M E N T ?
Y E S : E N T E R N O : E S C
(3) Press the ENTER key, and the adjustment confirmation cut is cut on the 2nd page by the cutter pin set on the tool
carriage. Feed direction.
'FFEJOHEJSFDUJPO
QBHFTQBHF QBHFT
9BNPVOUPGWBSJBODF
:BNPVOUPGWBSJBODF
$PSSFDUJPOJOQVUm9
$PSSFDUJPOJOQVUm:
$POGJSNUIFWBSJBODFPOUIFTFDPOEQBHF
(4) After the cut, the following is displayed.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >