2-8
Chapter 2 Preparation for Printing
2.4 Connecting to the Power Supply
This section explains how to turn on the power in this device.
Do not turn the power on until the label materials have been set.
When turning the power off and back on again, wait over ten seconds before switching back on.
The device may cease to work regardless of the reset if this time is not given.
(1) Make sure the power switch is in the Off (
) position.
(2) Connect one end of the attached power cables to the AC line inlet and the other end to an AC power outlet of the
rated supply voltage.
(3) Set the device power switch to the On ( | ) position. After initial operations, the control panel's READY lamp will light up.
In cases where the label materials are set normally, it is possible to load the label materials.
If the label materials are not set, the below message will display after showing the version.
'
'
'
'
L 0 1 : N o M e d i a
S e t t h e m e d i a i n t o
s t o c k e r .
T h e n p r e s s F E E D k e y .
To Next Page
Loading...