EasyManua.ls Logo

GRAPHTEC LABELROBO LCX603 - UsNg the Separator

GRAPHTEC LABELROBO LCX603
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-34
Chapter 2 Preparation for Printing
2.10 Using the Separator
Once the label materials are set, set the separator in the separator section.
Set the separator when the label materials have been set.
Refer to "2.6 Loading Label Materials (media)" regarding setting label materials.
Prior to using the separator function, refer to "2.9 Adjusting the Function Setting", and then turn
the "separator" on.
When using the separator, it is possible to use it smoothly if the separator winder bobbin is set in
the separator prior to setting the label materials.
When the set label materials are nearly new (many rolls remaining), the separator winder bobbin
becomes full before using up all the label materials. The extent to which it becomes full depends
on the cutting pattern and surrounding environment.When operated for a long period of time, set a
new paper tube in the separator winder bobbin.
The rewindable outer diameter varies according to the cutting pattern.
The shape of the separator winder bobbin is similar to the laminate winder bobbin. The section
with the large gears attached to shaft is the separator winder bobbin.
<Steps For When Using the Separator>
Step
Present Condition
Turn the power ON
(READY Status)
Set label
materials
Turn on separator
settings
Set in the
separator section
Power ON (READY Status)
Finished setting label materials
Step 1 Step 2
Power ON (READY Status)
Not finished setting label
materials
Step 1 Step 2 Step 3
Power OFF
Finished setting label materials
Step 1
Step 2 Step 3
Power OFF
Not finished setting label
materials
Step 1 Step 2 Step 3 Step 4
Reference
[Turn power ON]: Refer to "2.4 Connecting to the Power Supply".
[Setting label materials]: Refer to "2.5 Setting Label Materials (media)", "2.6 Loading Label Materials (media)".
[Turn on separator setting]: Refer to the latter "Turning On the Separator" section.
[Set in the separator section]: Refer to the latter "Setting the Separator" section.
<Media Route>
'FFESPMMFS
-BNJOBUFCBS
0VUMFU
1SFTTSPMMFS
$VUUFSVOJU
4FQBSBUPS
.FEJBTUPDLFS
4FQBSBUPSXJOEFSCPCCJO
%BODFSSPMMFS %BODFSSPMMFS

Table of Contents

Other manuals for GRAPHTEC LABELROBO LCX603