GRAPHTEC LABELROBO LCX603 - Chapter 2 Preparation for Printing; PreparNg the Cutter Pen; Cutter Pen Part Names; Cutter Pen Nomenclature

2-2
Chapter 2 Preparation for Printing
2.1 Preparing the Cutter Pen
The nomenclature and types of cutter pens are explained
Cutter Pen Part Names
In this device, the cutter blades are set and used in the cutter plunger. Set and use the blades in the suitable cutter
plunger.
$VUUFSCMBEF
1MVOHFS
1MVOHFSDBQ
#MBEFMFOHUIBEKVTUNFOULOPC
'PS#MVFNN
When handling the cutter blades, take full care not to cut your hands.
Cutter Pen Nomenclature
Ø0.9mm Cutter pen
Spring
Plunger
Blade length
adjustiment knob
(Blue)
Plunger cap
Ø0.9mm Cutter blade
Adjusting the Blade Length
The blade length must be adjusted to provide the most appropriate cut. Run the test cut several times and set the most
appropriate blade length.
The blade length varies depending on when the laminate is used/not used.
When handling the cutter blades, take full care not to cut your hands.
• Refer to "2.15 Cutting Test" with regards to the cutting test.
• Refer to "2.14 Adjusting the Blade Length" with regards to blade length adjustment methods.
The blade length is adjusted by turning the blade length adjustment knob. To extend the cutter blade, turn the knob in
the A direction. To retract the cutter blade, turn the knob in the B direction. When the knob is turned the distance of one
scale unit, the cutter blade moves 0.1 mm. When the knob is given one full turn, the cutter blade moves 0.5 mm.
# "
#MBEFFYUFOET
5IFDVUUFSCMBEF
NPWFTNNXJUI
POFTDBMFVOJU