GRAPHTEC LABELROBO LCX603 - The Label MaterAl Floats and the PrNt S Offset

7-14
Chapter 7 Troubleshooting
The Label Material Floats and the Print is Offset
Symptom/Cause
• The label material floats and a print offset occurs.
• When the label material is reset, when the printer is stopped for a long time following a set, or when the wrapped
edge of the label material is not even, the label material film separates from the backing and a floating phenomenon
can occur.
Solution
• When the seal section floats near the feed roller, take out the MEDIA ASSIST, cut the label material, pull it out, and
reset it.
'FFESPMMFS
'MPBUJOH 'MPBUJOH