GRAPHTEC LABELROBO LCX603 - PrNtNg Adjustment Pattern

4-25
Chapter 4 Menu Operation
4.14 DISTANCE ADJ. (Distance Adjustment)
The distance adjustment compensates for the length of the plot line generated according to the thickness and type of
the media used. As for the distance adjustment value, the length of the line is measured and entered.
The adjustment pattern is printed, and the correction value is entered as the distance adjustment.
Measure the distance between crosses printed with Head 3 (ribbon 3), and enter the correction value as Correction
Value = Measured Value - 190 mm.
The adjustment pattern outputs two layers. Measure the printing results, and enter the correction value.
Also, printing the distance removed data in the direction of the media feed, when setting the distance adjustment value,
refer to the User Pattern Correction printed below.
• When a reliable printing length is required because the adjustment value differs due to the
label material, laminate material type, presence or absence of laminate, ribbon type or printing
resolution (dpi), it will be necessary to adjust for every replacement and change.
• The material may expand or shrink to varying degrees based on the usage environment
(temperature, humidity).
• Set up 3 types of ink ribbons. When three types of ink ribbons have not been set, go to the User
Pattern Correction printed below.
• "Distance Adjustment" and "Head Position Adjustment" are possible with the pattern output in the
"adjustment pattern print".
• The distance adjustment value setting is stored even when the power is turned off.
• 130 mm width is necessary in the label material (media).
Adjustment Pattern Instructions
:
9
'JSTUQBHF
:
9
4FDPOEQBHF
)FBE3JCCPO3FE
<&YBNQMF>
)FBE3JCCPO#MVF
)FBE3JCCPO#MBDL
1SJOUFEXJUI)FBE
1SJOUFEXJUI)FBE
.FBTVSFUIFMFOHUI
)FBE3JCCPO3FE
<&YBNQMF>
)FBE3JCCPO#MVF
)FBE3JCCPO#MBDL
1SJOUFEXJUI)FBE
1SJOUFEXJUI)FBE
.FBTVSFUIFMFOHUI
'FFEJOHEJSFDUJPO
'FFEJOHEJSFDUJPO
8SJOLMF
QSFWFOUJPOMJOFT
8SJOLMF
QSFWFOUJPOMJOFT
Print 4 cross sections with Head 3. Print the connecting line segment with Head 1 in the first layer, and Head 2 in the
second layer.