4-24
Chapter 4 Menu Operation
(6) Press the F2 key (X-POSITION ADJ) and enter the correction value for direction x.
'
'
'
'
X - P O S I T I O N A D J U S T
< 0 . 0 > m m
A D J U S T : ↑ ↓
Y E S : E N T E R N O : E S C
Change the numerical value (-1.5 to +1.5) with the POSITION keys (
▲▼
) and program the correction value.
Press ENTER to confirm and return to the previous screen.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
(7) Press the F3 key (Y-POSITION ADJ) and enter the correction value for direction y.
'
'
'
'
Y - P O S I T I O N A D J U S T
< 0 . 0 > m m
A D J U S T : ↑ ↓
Y E S : E N T E R N O : E S C
Change the numerical value (-1.5 to +1.5) with the POSITION keys (
▲▼
) and program the correction value.
Press ENTER to confirm and return to the previous screen.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
Carry out the CUT CONFIRMATION. When there is still a shift in the print and cut, repeat the correction operation.
Verify that the print is overlapped with the cut, then press the LOCAL key, and finish.
To Next Page
Loading...