GRAPHTEC LABELROBO LCX603 - Page 121

4-23
Chapter 4 Menu Operation
(3) Press the ENTER key, and the adjustment confirmation cut is cut on the 3rd page by the cutter pin set on the tool
carriage.
'FFEEJSFDUJPO
QBHFTQBHF QBHFT QBHFT
7FSJGZUIBUUIFDFOUFSPGUIFQSJOUFEDSPTTJTDVU
(4) After the cut, the following is displayed.
'
'
'
'
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
Verify that the print is overlapped with the cut (cut the center of the printed crosses (+)), then press the LOCAL key,
and finish.
Also, when they do not overlap as shown below, perform the adjustment again.
'FFEEJSFDUJPO
QBHFTQBHF
QBHFT
QBHFT
$POGJSNUIFWBSJBODFPOUIFUIJSEQBHF
(5) Based on the crosses (+) for the correction reading that was read, measure how far you must slide the correction
crosses (+) cut for comparison so that they overlap, and record the value.
'FFEEJSFDUJPO
QBHF QBHFT QBHFT
:
9
:BNPVOUPGWBSJBODF
9BNPVOUPGWBSJBODF
$PSSFDUJPOJOQVUm:
$PSSFDUJPOJOQVUm9
$VUDSPTT
1SJOUFEDSPTT
For example in the above illustration, direction x and direction y are both misaligned in direction plus (+). As such,
it is necessary to correct to direction minus (–).
Each correction value will become a negative value.