GRAPHTEC LABELROBO LCX603 - CleanNg MedA GuDe

6-14
Chapter 6 Maintenance
6.10 Cleaning Media Guide
When the label material (media) cannot be set (it does not come up to the feed roller), and the label material bows etc.,
the media guide section becomes dirty, or foreign matter may get jammed in it.
In that case, remove the media stocker and clean the media guide.
Cleaning
(1) Confirm that the power is in the "off".
(2) Remove the media stocker, and remove the label material.
(3) Remove the media guide installation screws, and slowly pull the media guide forward.
3FNPWFTDSFXT
.FEJBHVJEF
4MPXMZQVMMGPSXBSEBGUFSSFNPWJOHUIFTDSFXT
(4) Clean the media guide with a cloth.
3FNPWFEJSU
3FNPWFEJSU
(5) Once cleaning is finished, return the media guide while matching the guide, then tighten the screws.
.BUDIUIFHVJEF .BUDIUIFHVJEF
4MPXMZTFUXIJMFNBUDIJOHUIFHVJEF
5JHIUFOUIFTDSFXT
(6) Set the media guide.