2-54
Chapter 2 Preparation for Printing
2.17 CROSS CUT Key
If the CROSS CUT key is pushed in READY status, the label materials will be cut horizontally.
• The cross cutting operation occurs close to the outlet. Take full care not to injure your fingers from the
blade.
• Cross cut is for cutting the backing sheet of label materials following the separator. There may be uncut
materials if you try to cut label materials by backing sheet or with attached laminate materials. Also, the
crosscut section might be damaged if the label material glue attaches to the blade.
Do not cut anything other than the backing sheet. Refer to "4.21 CROSS CUT" for crosscut settings.
Operating Instructions
(1) Press the CROSS CUT key from READY operation status.
The below message will display, and backing sheet section of the label materials will be horizontally cut at the
current position.
'
'
'
'
P R O C E S S I N G
The status will return to READY once cutting is completed.
To Next Page
Loading...