7-19
Chapter 7 Troubleshooting
Unable to peel properly with separator (weed)
Symptom/Cause
When the gap between two labels is too narrow, the separator (weed) section becomes too thin and they are not
sufficiently separated.
When performing continuous printing or unmanned operation, be sure to verify that the separator (weed) is performing
properly; when the weed does not occur, increase the label gap, adjust the blade length or cutting force, etc.; if that is
not effective, change the materials set method so that the weed is not performed.
The label weed is performed after the cut, but due to the label material, label shape, size, or arrangement of two labels,
there are cases where the weed does not occur, or the label material itself is cut.
Solution
Enable the Frame Cut (on); after cutting the border, wind it with the separator. (Refer to “4.22 FRAME CUT.”)
• The shape makes weeding difficult
Change the type or combination of label material or laminate material.
(1) Inside of the donut shape (shaded section)
(2) Latter half of polygon (shaded section)
To Next Page
Loading...