GRAPHTEC LABELROBO LCX603 - SettNg MedA AssStance

2-13
Chapter 2 Preparation for Printing
2.6 Loading Label Materials (media)
Pull out the label materials set by the media stocker and set when ready to use.
• Be sure to load when media assistance has been installed.
• Refer to "2.5 Setting Label Materials
(media)
" for setting label materials in the media stocker.
• When using the separator, turn on the separator when the label materials are set and set the
separator.
• When setting the laminate, turn on the laminate when the label materials are set and set the
laminate.
• The separator can be run smoothly when the stocker is set in the separator section prior to
setting the label materials. (Refer to "2.10 Using the Separator".)
• With the exception of replacing label materials, do not pull out the media stocker. If the media
stocker is pulled out when it is set, the label materials may loosen and printer banding might occur.
• Resuming use of the device after it has been left unattended for a long time with label materials
set in place may negatively impacr the carrier motion for the label materials depending on the
surrounding environment and nature of the label materials being used. Be sure to remove label
materials if the device is going to be left unattended for a long time.
<Media Route>
'FFESPMMFS
-BNJOBUFCBS
0VUMFU
1SFTTSPMMFS
%BODFSSPMMFS
%BODFSSPMMFS
$VUUFSVOJU
.FEJBTUPDLFS
Setting Media Assistance
When setting the label materials (media) and feeding the source, always do so when media assistance is installed. If the
ribbon stalker is already set, replace it with media assistance.
If the label materials (media) are source fed when the ribbon stocker is set, the label materials may
become jammed. Always set the label materials when media assistance is installed.
(1) Open the main body front cover.