GRAPHTEC LABELROBO LCX603 - Page 44

2-12
Chapter 2 Preparation for Printing
(7) Set the media stocker. Withdraw the label material tip up to the stocker tip and set it exactly straight along the
scale of the media width.
However, be sure not to go over the tip of the label material.
• When setting the flange, do so with both hands.
• Set the label materials exactly straight along the scale seal.
• Slightly draw out the label material, insert it below the roller, and withdraw twisting the knob.
• Do not bend or rip the tip of the label materials. Furthermore, trim the end straightly.
• Set so that the tip of the label materials are in the position shown in the below diagram. An error
will occur if it isn't set correctly.
4FUUIFMBCFMNBUFSJBMUJQUPCFBUUIJTQPTJUJPO
4UFQ
4UFQ
4UFQ
(FBS
4DBMFTFBM
(8) Set the media stocker in the printer body.
• Close the media stocker while slightly lifting it.
• Be careful of dropping the media stocker as it is heavy.
With the exception of replacing label materials, do not pull out the media stocker. If the media
stocker is pulled out when it is set, the label materials may loosen and printer banding might
occur.