GRAPHTEC LABELROBO LCX603 - 4.22 Frame Cut

4-39
Chapter 4 Menu Operation
4.22 FRAME CUT
Program to use or not use frame cut (outline cutting).
When programming to use frame cut, cut the outline conforming to the indicated plotting area in the printer driver when
printing/cutting.
Frame Cut
Residue removal may become difficult in the separator unit depending on the configuration of the labels being
produced or label material type (25 μm materials or paper-type materials).In such cases you will have to peel with your
hands, but insert a cutting line in the outline of the sheet and remove excess residue in the separator unit. Horizontal
cutting afterward will become smooth as a result.
'FFEEJSFDUJPO
4UBSUNBSL
'SBNFDVU
In sequence number creation application software, etc., there is a function that lays out sequence numbers or bar
codes in the sheet by designing single layer labels. However, they are conversely not able to indicate a cutting line for
outline cutting. As such, the LCX603 will match the paper size and cut the outline.
When using thin materials below 25 μm (Keshi-N25) or weak paper-type materials, please use this
frame cut mode in free-configuration labels such as star shapes, or in small-shape labels.
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the below screen will display.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the below screen appears.
'
'
'
'
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4