GRAPHTEC LABELROBO LCX603 - When OperatOn S Strange

7-6
Chapter 7 Troubleshooting
When Operation is Strange
Symptom Cause Solution
The DATA lamp does not blink even
when data is transmitted.
Data is not being properly transmitted. Verify that the interface cable is
properly plugged in.
Media is bowed. The media is set at a slant. Correct the setting of the media.
The media has been set, but even
when the set lever is raise, "Please set
the media" is displayed.
There is a possibility that something
wrong has occurred in the operation of
the set lever sensor.
Please contact the distributor where
you purchased the unit or your nearest
Graphtec vender.
"RMS Sensor Error" comes up. Registration marks are not printed in
black.
Make ribbon 3 black.
Registration marks are cracked. Verify the Density Settings.
"Print Data Error" is displayed. Data that cannot be verified has been
received.
Verify the data.
The separator does not operate. The separator setting is OFF. Please turn ON the separator setting
in the function settings.
The laminator does not operate. The laminator setting is OFF. Please turn ON the laminator setting in
the function settings.
Cross cut cannot be done. The cross cut setting is OFF. Please turn ON the cross cut setting in
the function settings.
The separator is not separating. When the separator does not separate,
cross cut does not perform well.
Perform the separator operation.
Do not perform the cutting operation. Cutting data is contained within the
data.
Verify the data.
The cut line width is too thick. Make the cut line the thinnest line.
The cut line color selection is different. Verify the driver software setting.
Paper setting cannot be done well,
and a "Printer Jamming" is displayed.
A jam has occurred because the end
of the media has not been lined up.
Cut the end of the media neatly.
Set the ribbon cassette. The ribbon cassette has not been set,
and the delivery of media does not go
well.
A "Printer Jamming" comes up. The dancer roller has not been set. Set the dancer roller.
Dancer roller failure. Please contact the distributor where
you purchased the unit or your nearest
Graphtec vender.