GRAPHTEC LABELROBO LCX603 - TurnNg on the Separator; SettNg the Separator

2-35
Chapter 2 Preparation for Printing
Turning on the Separator
(1) Press the LOCAL key on the control panel.
(2) Press the F1 key (PRINTER MENU) and press the NEXT key twice. Press the F3 key (FUNCTION SETTING) in the
[3/4] screen.
'
'
'
'
'
'
'
'
'
'
'
'
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
4FMFDU13*/5&3.&/6'LFZ
4FMFDU'6/$5*0/4&55*/('LFZ
5IFNFOVTXJUDIFTCZ
QSFTTJOHUIF/&95LFZ
POMZJOUIFQSJOUNFOV
'LFZ
/FYULFZ
/FYULFZ
(3) Press the F2 key (SEPARATOR), use the POSITION keys (
▲▼
) to turn the separator on, and press the ENTER key
to confirm.
'
'
'
'
'
'
'
'
L A M I N A T E >
S E P A R A T O R >
C R O S S C U T >
F R A M E C U T >
S E P A R A T O R S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
6TFUIFBSSPXLFZTUP
UVSOUIFTFQBSBUPSPO
',FZ
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.
Setting the Separator
(1) Remove dancer roller 2 from the separator side and open the separator section.
Always remove the dancer roller before opening the separator.
Dancer roller 2 Separator
Step 2
Step 1