2-36
Chapter 2 Preparation for Printing
(2) Remove when the separator winder bobbin is set.
(3) Loosen and remove the separator flange collar, then remove the separator winder bobbin flange. (The flange on
the gear-side is fastened.)
• The larger white gear is for winding.
• Be carefull that the separator flange collar doesn't drop.
(4) Install the flange into the form tube of the separator winder bobbin. Fasten so that there is no opening in between
the form tube and flange.
• Use either an auxiliary form tube or the form tube of a used ink ribbon.
• Fasten the separator flange collar all the way in when installing.
To Next Page
Loading...