5-29
Chapter 5 Replacing Consumable Items
5.5 Setting/Adjustment During Replacement
Replacing Label Materials and Laminate Materials
If the label and laminate materials are changed to a different type, the below setting changes and adjustment are
necessary:
Items to be carried out always
• Cutter blade length adjustment ...................."2.14. Adjusting the Blade Length"
• Test Cut ........................................................."2.15. Cutting Test"
Items to be carried out when necessary
• Printing and cutting position adjustment ......"4.15 HEAD POSITION ADJUSTMENT"
• Distance adjustment ....................................."4.14 DISTANCE ADJ. (Distance Adjustment)"
• Printing Test Pattern ......................................"4.12. PRINT TEST PATTERN"
• Tool condition selection ................................"2.13 Selecting Tool Conditions"
• Print head cleaning ......................................."6.3. Cleaning the Thermal Head"
• Paper size change. ......................................."3.3 Printer Driver Operation" (Paper Size)
Run a test print once when replacing the materials or ribbons. Make fully sure the positioning and
printing characteristics match the materials or ribbons When changing to a different type of ink
ribbon.
When the ink ribbon has been replaced
When the ink ribbon has been replaced with a different type, the following setting changes are necessary:
• Switching the head pressure adjustment plate ..... "2.8 Setting the Ink Ribbon" (Switching the RESIN and Semi-RESIN ink ribbon)
• Setting printing density .................................... "4.9 PRINTING DENSITY"
Run a test print once when replacing the materials or ribbons. Make fully sure the positioning and
printing characteristics match the materials or ribbons
To Next Page
Loading...