GRAPHTEC LABELROBO LCX603 - Page 176

5-28
Chapter 5 Replacing Consumable Items
(9) Pull the backing sheet from the outlet side, and straighten it as the label materials are being pulled.
Close the separator and set dancer roller 2.
Set the dance roller exactly straight along the scale seal.
%BODFSPMMFS4FQBSBUPS
4UFQ
1VMMPVU
UIFCBDLJOHTIFFU
4UFQ 4UFQ
PresstheFEEDkey,andalwaysmakesurethelabelmateralloadsandsrolledupntheseparatorwnderbobbn.
When the below message is displayed, release the ribbon lever set-up.
'
'
'
'
W 0 4 : L o a d i n g c h e c k
R i b b o n l e v e r i s s e t .
C a n n o t f e e d .
Y E S : E N T E R