GRAPHTEC LABELROBO LCX603 - Page PrNt Mode

4-15
Chapter 4 Menu Operation
4.10 PAGE PRINT MODE
In the PAGE PRINT MODE, set HEAD 3, HEAD 2, or Do Not Use (OFF).
Typically, use with the Head 3 setting.
When the page length exceeds 65 mm, there are cases where the printing inconsistency is conspicuous at the print
stop position. When using this function, it is possible to move the printing inconsistency into the front or back margin
along the media feed direction.
*Pagelengthreferstolengthoftheprntareamedafeeddrectonforonepage.
Head 3 ................Perform Head 3 printing on each page, and the above printing inconsistency can be moved into the
front or back margin of the page.
Head
2 ................Perform Head 2 printing on each page, and the above printing inconsistency can be moved into the
front or back margin of the page.
OFF .....................Do not use this function.
When shipped from the factory, the device is set to Head
2.
In the PAGE PRINT MODE setting, please pay attention to the following items.
• When changing the setting details, perform the OUTPUT ALL operation when there is data being printed.
• The length of the margin page is automatically adjusted according to the length of the page being printed, and
the maximum length is 215 mm. When the length of all pages being printed is 150 mm or more, a margin is not
generated.
• When using a page length less than 150 mm, frequently switching, and a lot of margin pages are generated, try using
the OFF setting.
• When the printing inconsistency described above is conspicuous in the Head 2 printing results due to printing data,
try using the Head 2 setting.
In this case, since the Head 3 print stop position is within the page, if there is both Head 3 and Head 2 printing data,
please use caution.
• When the PAGE PRINT MODE is set to either Head 2 or Head 3, consecutively printing data with varying page
lengths may cause Dancer Roller 1 to touch the bottom, thereby causing the media to slacken. Should this occur,
group together print data with the same page lengths and print that data collectively.
• When using the Head 3 or Head 2 setting, and the page length is usually 65 mm, it is possible to
place the printing inconsistency for all 3 heads in the margin at the front or back of the page.
• When shipped from the factory, the device is set to Head 3.
ExampleofWhenHead3nconsstencysConspcuous:changngfromtheOFFsettngtoHead3(refertothefgurebelow)
'FFEJOHEJSFDUJPO
'FFEJOHEJSFDUJPO
-BCFM
0GGTFUUJOH
-BCFM
-BCFM
)FBETFUUJOH
-BCFM
1BHFMFOHUI
)FBEQSJOUJOH )FBEQSJOUJOH
1PJOUTJOXIJDIIFBEQSJOUJOH
JODPOTJTUFODJFTBSFDPOTQJDVPVT
1BHFMFOHUI
)FBEQSJOUJOH )FBEQSJOUJOH
1PJOUTJOXIJDIIFBEQSJOUJOH
JODPOTJTUFODJFTBSFDPOTQJDVPVT