GRAPHTEC LABELROBO LCX603 - Page 112

4-14
Chapter 4 Menu Operation
(3) Press the NEXT key until the following is displayed.
'
'
'
'
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
(4) Press the F1 key (PRINT SETTING) and the following is displayed.
'
'
'
'
P R I N T I N G D E N S I T Y >
P A G E P R I N T M O D E >
A N T I - W R I N K L E L I N E S >
(5) Press the F1 key (PRINTING DENSITY) and the following is displayed.
'
'
'
'
C O N S T R U C T I O N M E D I A >
D E N S I T Y H E A D 3 >
D E N S I T Y H E A D 2 >
D E N S I T Y H E A D 1 >
(6) Press the F4 key (DENSITY HEAD1) and the following is displayed.
In the case of HEAD 2 press, the F3 key; in the case of HEAD 3, press the F2 key.
'
'
'
'
H E A D 1 R I B B O N T Y P E
< S e m i - R E S I N >
S E L E C T :
Y E S : E N T E R N O : E S C
With the POSITION keys (
▲▼
), to set the Semi-RESIN and RESIN that are to be used, change them.
Set only the Semi-RESIN, depending on the media currently used.
(7) Press the ENTER key (YES) and the following is displayed.
'
'
'
'
H E A D 1 D E N S I T Y
< 3 5 >
A D J U S T : ↑ ↓
Y E S : E N T E R N O : E S C
(8) Change the number with the POSITION keys (
▲▼
), and set the printing density. The lower the number, the lower
the printing density and vice versa.
The valid range depends on the types of media and ink ribbon currently set.
Confirm the message, decide with the ENTER key, the display returns to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.
Set to the Media Type Setting (MEDIA TYPE) and Density Settings (PRINTING DENSITY) based on
the Before Using the Printer (LCX603 Additional User's Manual).