GRAPHTEC LABELROBO LCX603 - TroubleshootNg Related to PrNtNg; Characters N the FLled Area Are ShFted DurNg 2-Color PrNtNg

7-2
Chapter 7 Troubleshooting
7.1 Troubleshooting Related to Printing
Characters in the Filled Area are Shifted During 2-Color Printing
*When using software that can set the color mode, set to RGB color.
Symptom
When creating a seal as shown below, there are cases where a print shift occurs in the filled in perimeter.
4IJGUFE
(SBQIUFD
-$9
(SBQIUFD
(SBQIUFD
-$9
Cause
In the extracted section, a minute shift has occurred because the black characters overlap. Fine compensation
placements such as trapping or overprint are generally performed in software applications such as Illustrator, but in the
LCX603, this overprint can be performed with a driver setting.
Refer to the following for a concrete example.
Solution
(1) In this example, the cut line uses red. A cut line is drawn with the thinnest line in the application (thickness 0, 1 dot
line, etc.). Create closed figures.
When thin lines with the same colors as those set for the cutlines are present on the
data, depending on the application being used, said lines may be perceived as being
cutlines and cut as a result. In such instances, either widen the width of the lines that
were excessively cut, or change the data-based color of the lines set for the cutlines,
followed by changing the color under “ Select Cutline” in the driver to match the actual
cutlines.
(SBQIUFD
-$9
5IFUIJOOFTUSFEMJOF
(2) A label draft could be created on screen. However, when output as-is to the LCX603, it becomes as shown below.
(SBQIUFD
-$9
(SBQIUFD
(SBQIUFD
(SBQIUFD
-$9
:FMMPX
)FBEQSJOUEBUB
)FBE#MBDL)FBE:FMMPX$VU-JOF3FE
)FBEQSJOUEBUB
#MBDL