GRAPHTEC LABELROBO LCX603 - When LamNate MaterAl S Wrapped up N the Press Roller

7-18
Chapter 7 Troubleshooting
When Laminate Material Is Wrapped Up in the Press Roller
Symptom/Cause
• When the laminate material is set, when there is slack in the take up of the laminate material or its backing, it can get
wrapped up.
Solution
• Open the press lever.
• Slowly pull up the wrapped up backing so as not to cut the laminate material.
8SBQQFEVQ
CBDLJOH
1SFTTSPMMFS
8SBQQFEVQ
1VMMPVU
UIFXSBQQFEVQQPSUJPO
-BNJOBUF
NBUFSJBM
'FFE
SPMMFS
• After pulling it out, do the following. After pulling it out, close the press lever.
1SFTTSPMMFS
'FFESPMMFS