GRAPHTEC LABELROBO LCX603 - Label PrNter Part Names; Part Names 1

1-4
Chapter 1 Product Summary
1.3 Label Printer Part Names
Part Names 1
Control panel
Label tray
Outlet
Cross cutter unit
Laminate stocker
Separator
winder bobbin
Separator
Dancer roller 1
Press roller
Feed roller
Laminate bar
Cutter unit
Press lever
Laminate winder bobbin
Dancer roller 2
Controlpanel ..................................Carry out operations and various settings.
Separator ........................................Set when unnecessary media is detached.
Separatorwnderbobbn ................Rolls up detached unnecessary media.
Presslever ......................................Opens and closes the press roller when the media is set.
Lamnatebar ...................................Used when laminate is set.
Lamnatewnderbobbn .................Rolls up the laminate backing sheet.
Lamnatestocker ............................Sets the laminate.
Feedroller
.......................................Feeds the media.
Pressroller .....................................Thrusts the media into the feed roller.
Dancerroller(1,2) ..........................Used when setting/feeding media.
Cutterunt .......................................Cuts (stenciling, frame-cutting) media.
Labeltray ........................................Tray that receives completed labels.
Crosscutterunt .............................Cutter used for cross-cutting (horizontal cutting) media.
Outlet ..............................................Section that outputs media.