GRAPHTEC LABELROBO LCX603 - PrNt Test Pattern

4-18
Chapter 4 Menu Operation
4.12 PRINT TEST PATTERN
The fill printing state of each head can be confirmed by printing a test pattern.
Label material (media) with a width of 130 mm width is required.
• Set three types of ink ribbon and set the ribbon bar. If 3-type ink ribbons are not set, the Print Test
Pattern cannot be run.
• Print after winding-up until the transparent film section of the ink ribbon cannot be seen.
• There are cases where printing is faint and not uniform immediately after setting the ink ribbon. In
that case, run another test pattern.
• Before running the test pattern, set the PRINTING DENSITY. (Refer to "4.9 PRINTING DENSITY".)
• The head position shift is adjusted under HEAD POSITION ADJUSTMENT (Refer to "4.15 HEAD
POSITION ADJUSTMENT".)
Test Pattern Instructions
:
9
'FFEJOH%JSFDUJPO
)FBE3JCCPO
)FBE3JCCPO
)FBE3JCCPO
)FBE3JCCPO
)FBE3JCCPO
)FBE3JCCPO
Print Test Pattern
(1) Press the LOCAL key from the READY status and the following is displayed.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the following is displayed.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the following is displayed.
'
'
'
'
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
(4) Press the F2 key (PRINT TEST PATTERN) and the following is displayed.
'
'
'
'
P R I N T T E S T P A T T E R N >
A D J U S T P & C P O S I T I O N >
(5) Press the F1 key (PRINT TEST PATTERN) and the following is displayed.
'
'
'
'
P R I N T T E S T P A T T E R N ?
Y E S : E N T E R N O : E S C
(6) The test pattern is printed with the ENTER key.
Press the ESC key to return to the previous screen.