4-17
Chapter 4 Menu Operation
4.11 ANTI-WRINKLE LINES
Set whether to print the anti-wrinkle lines or not.
When set to ON, a line about 1.3 mm wide is printed outside the printing area in the direction of the width of the media
printing data, and wrinkling is prevented.
Typically, use this device with the lines printed (ON).
When shipped from the factory, the device is set to ON.
• When the balance of the print data position is poor, wrinkles occur on the ribbon during printing, and there are cases
where this has an effect on the printing result. In a case such as this, set to ON.
• We cannot guarantee that there will not be wrinkles in the printing results under all printing conditions. With respect to
other wrinkles, refer to Chapter 7 Troubleshooting.
• When not necessary, please use with the device set to not print the lines (OFF).
'FFEJOHEJSFDUJPO
"OUJXSJOLMFMJOFT
(1) Press the LOCAL key from the READY status and the following is displayed.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the following is displayed.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the following is displayed.
'
'
'
'
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
(4) Press the F1 key (PRINT SETTING) and the following is displayed.
'
'
'
'
P R I N T I N G D E N S I T Y >
P A G E P R I N T M O D E >
A N T I - W R I N K L E L I N E S >
(5) Press the F3 key (ANTI-WRINKLE LINES) and the following is displayed.
'
'
'
'
A N T I - W R I N K L E L I N E S
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(6) Change to ON (use ) or OFF (do not use ) with the POSITION keys (
▲▼
), and set the ANTI-WRINKLE LINES.
Press ENTER to confirm and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.
To Next Page
Loading...