GRAPHTEC LABELROBO LCX603 - AdjustNg the FunctOn SettNg

2-33
Chapter 2 Preparation for Printing
2.9 Adjusting the Function Setting
With the function setting you can turn on/off laminate, separator, and cross cut.
During feeding, release all ribbon levers and open the press lever.
(1) Press the LOCAL key on the control panel.
(2) Press the F1 key (PRINTER MENU) and press the NEXT key twice. Press the F3 key (FUNCTION SETTING) in the
[3/4] screen.
'
'
'
'
'
'
'
'
'
'
'
'
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
4FMFDU13*/5&3.&/6'LFZ
4FMFDU'6/$5*0/4&55*/('LFZ
5IFNFOVTXJUDIFTCZ
QSFTTJOHUIF/&95LFZ
POMZJOUIFQSJOUNFOV
'LFZ
/FYULFZ
/FYULFZ
(3) Press F1 - F3 for laminate, separator, and cross cut, and use the POSITION keys (
▲▼
) to switch ON/OFF. Press
the ENTER key to confirm.
'
'
'
'
'
'
'
'
'
'
'
'
'
'
'
'
L A M I N A T E >
S E P A R A T O R >
C R O S S C U T >
F R A M E C U T >
L A M I N A T E S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
S E P A R A T O R S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
C R O S S C U T S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
4XJUDI0/0''
'LFZ
4XJUDI0/0''
'LFZ
4XJUDI0/0''
'LFZ
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.