4-41
Chapter 4 Menu Operation
4.23 SETTING INTERFACE
This section will explain how to program the interface. There is a USB/network (LAN) interface in this device, and each
switch will run automatically.
The interface setting is only needed when connecting with a network (LAN) cable.
It is not needed when connecting with a USB cable.
If the network settings are changed, it will be necessary to turn off the power once, wait at least 10
seconds, and then turn it back on. After turning the power back on again, the settings will become
active.
When using this device, it will be necessary to install the driver software in your computer. Refer to "Chapter 3 Printer
Driver" regarding installing the driver software.
USB Interface
When using the USB interface, make sure the driver software is installed in your computer.
Operation cannot be guaranteed in the following cases:
• When connection has been made to a USB hub or an add-on USB board
• When you are using a custom-built computer or one that you have modified
• When a driver other than the one provided was used
Be sure to observe the following:
• Do not connect or disconnect the USB cable while you are installing the USB driver
• Do not connect or disconnect the USB cable while starting up the computer or the printer. Do not
disconnect the USB cable within a 5-second period of connecting it.
• Do not connect or disconnect the USB cable while data is being transferred. Do not connect our multiple
products to a single computer.
Network (LAN) Interface
When using the network (LAN) interface, complete the machine settings such as your computer and network hub. It
will be necessary for the computer to be connected to the network. In addition, change the settings to temporarily turn
off the firewall. When turning off the firewall function, disconnect the network from the internet.
• A network (LAN) cable or network hub is needed in order to connect to the Landmarked separate
preparations.
• Network device configurations and the availability of router functions will vary depending on the
environment you are using. Refer to your device's manual, or contact the manufacturer or network
administrator for details.
• Ethernet conforms to 10BASE-T/100BASE-TX. Confirm the network environment you are using.
To Next Page
Loading...