GRAPHTEC LABELROBO LCX603 - Page 134

4-36
Chapter 4 Menu Operation
4.19 LAMINATE
Program whether or not to use laminate.
When programming to use laminate, apply the laminate materials to the media surface after printing.
• When this menu setting and the set-up condition of this main unit are not in agreement, an error
will occur and it will not be possible to print.
• When programming to not use laminate, always remove the laminate materials from the stocker. If
they are left set, an error will occur and it will not be possible to print.
• When programming to use laminate, always set the laminate materials. If they are not set, an error
will occur and it will not be possible to print.
• Refer to "2.11 Using the Laminate" regarding setting laminate.
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the below screen will display.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the below screen appears.
'
'
'
'
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
(4) Press the F3 key (FUNCTION SETTING) and the below message will display.
'
'
'
'
L A M I N A T E >
S E P A R A T O R >
C R O S S C U T >
F R A M E C U T >
(5) Press the F1 key (LAMINATE) and the below message will display.
'
'
'
'
L A M I N A T E S E T T I N G
< O N >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(6) Change to "ON" (use laminate) or "OFF" (do not use laminate) with the POSITION (
▲▼
) keys and program laminate.
Press ENTER to confirm and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.