4-12
Chapter 4 Menu Operation
4.9 PRINTING DENSITY
Perform the print printing density.
This device is a thermal ink-transfer printer using a thermal head. The "DENSITY" here is the setting of the thermal units
(temperature) for the ribbon that transcribes ink.
It is necessary to set the optimal value for both the label material (media) and the head (ribbon).
Set to the Media Type Setting (MEDIA TYPE) and Density Settings (PRINTING DENSITY) based on the Before Using
the Printer (LCX603 Additional User's Manual).
• If the MEDIA TYPE is set to OFF (No settings), it is possible that the values will be set to outside those
given in the Density Settings (PRINTING DENSITY) guarantee.
• If used in a way not covered by the Density Settings (PRINTING DENSITY) guarantee, depending on the
print data, the printing may be satisfactory but the ink ribbon may be burned onto the print head and it may
become necessary to clean it frequently. If genuine supply products are used, even if values outside of the
Density Settings (PRINTING DENSITY) guarantee are used, it will not cause the device to break down.
If values outside of the Density Settings (PRINTING DENSITY) guarantee are used, then the responsibility
lies with the customer.
• In the case of values outside of the Density Settings (PRINTING DENSITY) guarantee being used, a
warning message will be displayed.
• When "MEDIA TYPE" in "CONSTRUCTION" is set to "OFF", the following is displayed.
'
'
'
'
C a u t i o n : R i b b o n i s
d a m a g e d b y t h e H i g h
D e n s i t y . C o n t i n u e ?
Y E S : E N T E R N O : E S C
Press the ENTER key (YES) to return to CONSTRUCTION screen with saving the settings.
Press the ESC key (NO) to return to MEDIA TYPE screen without saving the settings.
• In the case of values outside of the Density Settings (PRINTING DENSITY) guarantee being used, when
"MEDIA TYPE" in "CONSTRUCTION" is set to "OFF", the following is displayed.
'
'
'
'
H i g h D e n s i t y w i l l b e
s e t . R i b b o n m a y b e
d a m a g e d . C o n t i n u e ?
Y E S : E N T E R N O : E S C
Press the ENTER key (YES) to return to CONSTRUCTION screen with saving the settings.
Press the ESC key (NO) to return to MEDIA TYPE screen without saving the settings
• For this device, because of the thermal ink‐transfer printing using a thermal head, the color will not
be darker just by increasing this value. Also, please use caution, because if this value is increased
more than necessary, cracking or ribbon breakage can occur.
• The heads (ribbons) are in the order 1, 2, and 3 from the bottom of the ribbon stocker.
• When selecting ribbon 2 color printing or ribbon 3 color printing, be sure to set Head 1, Head 2, and
Head 3 respectively.
•
When the media is changed in "MEDIA TYPE” in" CONSTRUCTION", the following is displayed.
'
'
'
'
C o n f i r m a t i o n : D E N S I T Y
i s s e t t o d e f a u l t
v a l u e . C o n t i n u e ?
Y E S : E N T E R N O : E S C
Press the ENTER key (YES) to return to CONSTRUCTION screen with saving the settings.
Press the ESC key (NO) to return to MEDIA TYPE screen without saving the settings.
To Next Page
Loading...