GRAPHTEC LABELROBO LCX603 - Page 132

4-34
Chapter 4 Menu Operation
4.17 REGISTRATION MARK
Read the programmed registration mark in the cutter section and run cutting to match the registration mark.
Select axis adjustment from "1POINT" and "3POINT".
Use axis adjustment (tilt adjustment) and distance adjustment in the following manner.
1POINT ..........................Adjusts from data starting point (origin) position for 1POINT adjustments.
3POINT ..........................Adjusts in 3 aspects of the registration mark for 3POINT adjustments: origin/x-axis direction/
y-axis direction.
The work time shortens when the registration mark setting is set to 1POINT, but the position
adjustment accuracy is inferior compared to 3POINT.Select 3POINT when an accurate position
adjustment is necessary.
'FFEJOHEJSFDUJPO
10*/5
'FFEJOHEJSFDUJPO
10*/5
0SJHJOSFHJTUSBUJPONBSL
/PUVTFE
JOSFBEJOHDPSSFDUJPO
0SJHJOSFHJTUSBUJPONBSL
:BYJTSFHJTUSBUJPONBSL
9BYJTSFHJTUSBUJPONBSL
:
9
:
9
(1) Press the LOCAL key from the READY status and the below message will display.
'
'
'
'
P R I N T E R M E N U >
C U T T E R M E N U >
O U T P U T A L L >
(2) Press the F1 key (PRINTER MENU) and the below screen will display.
'
'
'
'
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
(3) Press the NEXT key until the below screen appears.
'
'
'
'
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
(4) Press the F1 key (REGISTRATION MARK) and the below screen will display.
'
'
'
'
R E G I S T R A I O N M A R K
T Y P E < 3 P O I N T >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
(5) Change "1POINT" and "3POINT" with the POSITION (
▲▼
) keys, and program the utilized registration mark when
adjusting.
Press ENTER to confirm and return to the previous screen.
Press the ESC key to return to the previous screen.
Press the LOCAL key to return to READY status.