GRAPHTEC LABELROBO LCX603 - Page 163

5-15
Chapter 5 Replacing Consumable Items
(12) Set the media stocker. Withdraw the label material tip up to the stocker tip and set it exactly straight along the
scale of the media width.
However, be sure not to go over the tip of the label material.
• When setting the flange, do so with both hands.
• Set the label material exactly straight along the scale seal.
• Slightly draw out the label material, insert it below the roller, and withdraw twisting the knob.
• Do not bend or rip the tip of the label materials.
• Set so that the tip of the label materials are in the position shown in the below diagram. An error
will occur if it isn't set correctly.
4FUUIFMBCFMNBUFSJBMUJQUPCFBUUIJTQPTJUJPO
4UFQ
4UFQ
4UFQ
(FBS
4DBMFTFBM
(13) Set the media stocker in the printer body.
• Close the media stocker while slightly lifting it.
• Be careful of dropping the media stocker as it is heavy.
(14) Feed the label materials. Refer to "2.6 Loading Label Materials (media)
"
.
When setting the label materials (media) and feeding the source, always do so when media
assistance is installed. Refer to "Setting Media Assistance" in "2.6 Loading Label Materials
(media)" regarding setting media assistance.