GRAPHTEC LABELROBO LCX603 - Page 165

5-17
Chapter 5 Replacing Consumable Items
Switching Between RESIN and Semi-RESIN Ink Ribbons
There are two types of ink ribbons: RESIN and Semi-RESIN.
• RESIN (Resin-type) ......................
RP120-***
• Semi-RESIN (Wax-type) ..............
WD120-***
Refer to "Types and Characteristics of Ink Ribbons" in "2.8 Setting the Ink Ribbon" regarding ribbon types.
There are switchable head pressure adjustment plates depending on the type of utilized ink ribbon when setting the
ribbon cassette.
There are switchable head pressure adjustment plates depending on the type of utilized ink ribbon when setting the
ribbon cassette.
Should the position of the head pressure adjustment plate and the ink ribbon type be inconsistent,
printing quality may be adversely affected.
3&4*/
4FNJ3
3&4*/
4FNJ3
4UFQ
1SFTTUIFMFWFS
-FWFS
3JCCPODBTTFUUF
4UFQ
4MJEFUIFIFBEQSFTTVSF
BEKVTUNFOUQMBUF
)FBEQSFTTVSF
BEKVTUNFOUQMBUF
How to Switch the Head Pressure Adjustment Plate
• When using a RESIN ribbon, set the head pressure adjustment plate to the upper side.
• When using a Semi-RESIN ribbon, set the heat pressure plate to the lower side.
When switched to the proper position, the head pressure adjustment plate makes an audible click.
3&4*/
4FNJ3
3&4*/
4FNJ3
3&4*/
4FNJ3
3&4*/
4FNJ3
4UFQ
4MJEFUIFIFBEQSFTTVSFBEKVTUNFOUQMBUF
4UFQ
1SFTTUIFMFWFS
4UFQ
1SFTTUIFMFWFS
■4FNJ3&4*/ ■3&4*/
$MJDL
$MJDL
4UFQ
4MJEFUIFIFBEQSFTTVSF
BEKVTUNFOUQMBUF