5-25
Chapter 5 Replacing Consumable Items
(2) Remove the separator winder bobbin.
(3) Loosen and remove the flange suppression, remove the separator winder bobbin flange, and then remove any
wound up unneeded parts or form tubes. (The flange on the gear-side is fastened.)
Be careful that the separator flange collar desn't drop.
(4) Install the flange into the form tube of the separator winder bobbin. Fasten so that there is no opening in between
the form tube and flange.
• Use either an auxiliary form tube or the form tube of a used ink ribbon.
• Fasten the separator flange collar all the way in when installing.
To Next Page
Loading...
