6-10
Chapter 6 Maintenance
6.6 Replacing the Cutter Blades
When the cutter blade is worn, it is not possible to make a clean label border cut. In this case, the cutter blade can
be replaced, but even if the media glue or the media refuse sticks to the cutter blade or is jammed between the cutter
blade and the plunger, the border cut is degraded, and the quality of the roundness of the label corners is degraded
through the degradation of the turning of the cutter blade.
Periodically remove glue and refuse with a brush etc.
When handling the cutter blades, take full care not to cut your hands.
With regard to the cutter pen, refer to "2.1 Preparing the Cutter Pen".
Cutter Pen Nomenclature
Ø0.9mm Cutter pen
Spring
Plunger
Blade length
adjustiment knob
(Blue)
Plunger cap
Ø0.9mm Cutter blade
Replacing
(1) Turn the blade length adjustment knob in the B direction to retract the cutter blade inside the plunger.
0OUIFTDBMF
UIFDVUUFSCMBEF
QSPUSVEFTBCPVU
NN
# "
(2) Remove the plunger by turning the plunger cap in the counterclockwise direction.
(3) Remove the cutter blade from the plunger.
(4) Insert the replacement cutter blade with its spring attached inside the hole in the plunger cap.
(5) Attach the plunger to the plunger cap with the cutter blade inserted into it by lowering the plunger onto the plunger
cap.
To Next Page
Loading...