GRAPHTEC LABELROBO LCX603 - Page 36

2-4
Chapter 2 Preparation for Printing
2.2 Installing Tools (cutter pen)
The tools (cutter pen) are set in this device.
When installing the cutter pen in the tool holder, fully insert the cutter pen section in the below order until it bumps into
the top side of the tool holder. After the cutter pen is installed, tighten the screw. Furthermore, do not touch the pen tip
when the power has been turned on or during operation.
When pushing up the tool holder, take full care not to injure your fingers on the cutter blades.
(1) Loosen the tool holder screw.
(2) While pushing up the tool holder, fully insert the cutter pen section until it bumps into the top side of the tool holder.
Set the bracket to hold tool to cover the flange section of the cutter pen.
'MBOHF
#SBDLFUUPIPMEUPPM
(3) When the cutter pen is set, set the bracket to hold tool to cover the flange section and tighten the screw.
'MBOHF
#SBDLFUUPIPMEUPPM