GRAPHTEC LABELROBO LCX603 - Page 42

2-10
Chapter 2 Preparation for Printing
Setting the Label Materials (media)
(1) Remove the media stocker from the printer body
• Be careful of dropping the media stocker as it is heavy.
• When taking out the flange, take hold with both hands.
• The flange cannot be taken out when the media stocker is attached to the main body.
• The shape of the media stocker flange resembles the laminate stocker flange. The object with
the long shaft is the media stocker flange.
• Hold the assist handle of the media stocker section and don't lift up the main body.
4UFQ
.FEJBTUPDLFS
)BOEMF
4UFQ
(2) Remove the media stocker flange. The object with the long shaft is the media stocker flange.
Set the gear side in front.
(3) In order to adjust to fit the label material width, release the lock from the flange and shift the shaft.
4UFQ
4UFQ
4UFQ
1SFTTUIF164)TFDUJPO