GRAPHTEC LABELROBO LCX603 - Page 55

2-23
Chapter 2 Preparation for Printing
2.7 Setting the Push Roller
This section explains how to adjust the push roller position of the cutter unit
• Move the position of the push roller when the cam lever is opened (lowered).
• If the push roller is mounted on end of the label materials, the label material glue will adhere to the
push roller and may affect the degree of accuracy.
• Clean the push roller regularly (per one label material roll). Refer to "6.9 Cleaning Push Roller".
Setting the Push Roller
Adjust the position of the right and left push roller to match the width of the label materials.
-FGU3JHIUTJEFTBSFFWFO
(SJUSPMMFS
Move to position above both sides of the label materials (center is equal distance from left and right side) and grit roller.
0,
/(
/(
"UUBDIFEPOUIFMBCFMNBUFSJBM "UUBDIFEPOUIFDFOUFS
MFGUPSSJHIUTJEFPGUIFMBCFMNBUFSJBM
/PUBUUBDIFEPOUIFHSJUSPMMFS /PUBUUBDIFEPOUIFDFOUFS
MFGUPSSJHIUTJEFPGUIFMBCFMNBUFSJBM
/(
-FGU3JHIUTJEFTBSFFWFO